Sparing the long story, it has been way too long since I have been around. Rebuilt Dauntless V6, primed oil pump turning with a drill. Oil...
I have just completed an engine / transmission swap in my 64 cj5 from a 1971 donor vehicle. I did run the engine for a few minutes before...
64 cj5, D27 front axel with the disk brake swap. tires are a set of donated 31's with 50% tread on steel rims, but are balanced. driving down...
well the F head is running strong, this might be nit picky, but i would like to keep her running. Somthing I noticed, when the engine is cold,...
got the 134 f head in - it runs!!! the history of the engine is that it was pulled running fine from another jeep whose destinay is elswhere - I...
next question: the engine I am going to put into the jeep (hopefully later today) has a "Remanufactured" tag on it that looks like it was a...
ok pics will be here shortly, those of you who know me are aware of the oil problem I had with the first engine and how the problem ended up...
what are the advantages? I scored a running Fhead to replace the failed one I attempted to re-ring. It was in a 52 that a friend is doing a...
just heared back from the machine shop on the 134 Fhead. $603 for the labor to bore the block and put in new valve guides. $631.77 for new...
Back to the drawing board - disassembly update ok so the "puff of Blue Smoke" has become a fog, oil pressure at low rpms drops to zero, reving...
puff of blue smoke UPDATED 64cj5 134 F head complete overhaul, rings, gaskets, bearings, valve job and seals. Less than 500 miles on the...
most likely going to get slammed for this - but I have to vent somewhere. the victom 64cj5 - complete restoration, D27 up front with a disk...
I need to connect the 4 wire wiper motor (Red, Blue, Green and Black)to the wiper control in the sterring colom. I have the colom wires ID'd...
well - paperwork and insurance has been ready since this pass Friday, but I want everything legit since the temp inspecton sticker is just a 10...
The first ride Feels good
I am re routing the fuel line to the passanger side frame rail to get it away from teh exhaust. Also, I have picked up a new sending unit since...
having second thoughts on the dash of my 64 cj5. I wanted a really clean, plain look. The 2 origonal round gauges in there were the Amp gauge and...
ok - here's the scoop - I could not answer a buddies question about adding a PTO to the jeep (64 cj5) I do not have one - he is thinking it...
basicly there are 2 lighting curcits - the flashers, both hazz and turn then the running lights. The system is a single bulb, 2 element. If my...
on my 64 cj project, I have a fiberglass tube and hanging pedals. The accelerator is such, that it is designed to PULL a cable. the linkages on...
Separate names with a comma.