I have been searching this forum for about 6 months. What exactly would I use for search terms to find the right information. Many times when I...
I talked to Brian at Novak and he said I that the #C5 adapter kit would work. I would need a gm bellhousing with a BOP bolt pattern. Has anyone...
Can I keep my t98 and mate it to a buick 231. What will i need to make this work out.
I am considering a 231 upgrade from my f-134/t98/d18. What tranny would work the best if I retain my d18.
I am now considering a buick 231 even fire upgrade. What tranny would the most cost effective method. I have a f-134/t98/d18 set up now. Can I put...
What type of tranny would you suggest with a 4.3L upgrade from a F-134. I plan on light off road and highway. I have a '66 cj5. Trying to decide...
Looking for information on those who have upgraded to a GM 4.3L V6 in an early CJ pros and cons. I presently have a F-134 w/T98 four speed in a...
I just completed a disc conversion (GM 4x4 calipers) on front axle (D27) and in the process of a 11" upgrade on the rear(D44). The old wheel...
I am considering a 3" Lift from Black Diamond, do I need to shim the front and rear axles with this lift. Any other concearns a will have with a...
thanks.
I have a set of 4 tires that came with my jeep which are Buckshot Mudders Q78-16LT what size tire corresponds to the Q78.
Thanks to all that posted, it think this info will solve my problem minus a seal.
Does the seal go in with the part # facing outward and no gasket???????
The FSM shows one for the tapered axle which I have but does not show one for the flanged axle?????????. Where did you get your seal. I think Napa...
FSM # 13 calls it "Gasket" on exploded view of D44 in between the # 12 oil slinger and # 14 pinion oil seal. If changing the seal do I need this...
I just pulled the new oil seal out and a rubber seal came out also that was not part of the seal, where does it go.
I do not think so. When the nut is tightened to the correct specs "200 ft/lbs" is the yoke difficult to turn. Mine is difficult to turn with no...
Can anyone tell me if this is the correct rear pinion oil seal for a dana 44 and did I install it properly. Napa part # 15788 [ATTACH] [ATTACH]
Yes, I changed the seal only. The nut I took off with a impact and it did not take an extreme amount of effort. I punched a mark on the nut and...
I have big pipe wrench to keep the yoke from turning when I am torqueing the pinion nut. The problem is that about 50 ft/lbs the yoke(axle) is...
Separate names with a comma.