If possible, I sand blast what I'm working on. If I am painting the part with a spray can, I use Epoxy enamel appliance paint. That stuff is...
I'm currently looking for one to go on Dad's '72.... Its like hens teef... [img]
Re: HD drive shaft on the cheap Na, not a dead horse... just that that smiley! BTW, that is my write up on how I built my own DC rear driveline...
:dead horse: http://www.jeepforum.com/forum/f8/diy-double-cardan-rear-drive-line-cj-1444192/
This is in my CJ7. I have a new blank to build a new dash. My plan is to use a Autometer programmable speedo in the center, and surround it with 4...
I hooked a test light up to the A terminal. It flashes as it is supposed to. I hooked it up to the S terminal, and it still flashes, but dimmer as...
Yup, its the fuel gauge. I tested it, and the ohms are correct. Correct voltage at the terminals. The only thing I question is the 5v shown on...
Worked on Dad's CJ5 today for awhile. I troubleshot the back of the gauge cluster. Everything checks out. Plus, there is a new temp sending unit,...
Re: Suspention Kits Questions, what to buy? Caster angle should be adjusted anyway, unless your still running bias ply tires.
2nd box got here today! [img]
Time to buy a new pump. Pull the dip stick and make sure fuel is not getting into the oil as well.
Got 2 boxes today, 1 more tomorrow :driving: [img]
I already have a spare for my 82, I may just adapt that to fit and wire it up with a push button in the hand pump hole.
At this point you learn fun words like Ackerman angle....
Ok, here is a related question.. where should the squirter bottle be located, and what does it look like?
I figured that was the issue. I think of it as a good anti-theft device.....
That would make sense since there is not a windshield squirt bottle anywhere on the Jeep. Next I will have to check for the nozzles, and plumb up...
Due to early Jeeps running bias ply tires, there was little caster angle at the knuckles. With the advent of radial tires, the caster setting went...
Here is the lever just to the left of the ignition switch. [img] Back side of the switch [img]
As i was laying under the dash of my Dad's 72 CJ5 I noticed that there were two brake releases on the dash. One is hooked to the parking brake,...
Separate names with a comma.