I ordered a new PCV Valve from Peter DeBella for my F134. It has a male threaded end and a female threaded end. It looks like the male end goes to...
I'm just finishing the rebuild on my F134. I've gone to the fuel pump without the vacuum line for the wiper motor as I'll be running electric...
My F134 has a double groove crank pulley. What was the inside pulley used for if anything? It has a much smaller groove than the outside one but I...
On an F134 engine does anyone know if there was some sort of O ring or gasket on the distributor to seal between it and the block. My distributor...
I discovered why my distributor won't index like the service manual describes. I found out that the cam/advance plate in the distributor is...
According to the service manual the oil pump needs to be installed so the wide part of the distributor is nearest the top of the engine with the...
I'm assembling my F134 engine after getting it all back from the machine shop. I notice that the new oil pump has 2 oil flow holes (one at about 3...
My F134 has the cartridge oil filter housing and looks like it takes a Wix 51010 filter. Does anyone know if there is a small round rubber gasket...
Anyone know where I can buy a set or individual F134 head bolts. I haven't been able to locate any source for them. I may be able to locate some...
Anyone out there heard of a lightweight starter motor for the F134? As I rebuild my '63 CJ5 I'm looking for a few ways to lose some weight,...
I'm rebuliding an F134 for my '63 CJ5 and have a question many of you guys may know the answer to. My engine had a brass plug with a screwdriver...
Separate names with a comma.