It's been a long time since I've posted here. My Jeep's been down with a broke T14 for almost 2 years now. I've found a Ford T18 with the AA...
My :v6: fuel pump eccentric has a groove worn in it at the highest point. Would it be possible to repair it by welding up the groove and sanding...
I'm getting ready to replace the front seal in my V6. It currently has the rope type seal but I ordered a rubber replacement. Is it as simple as...
Last fall the input gear on my T14 broke 3 teeth. I wasn't being hard on it either, just normal driving. I want to get my Jeep back on the road as...
Does a full gasket set for a 225 include the rear main seal? How 'bout the timing cover seal?
How much wear is too much on the axle splines? Mine are worn to the extent that the splines have a sharp point at the top. The unused portion of...
I need to replace the spider gears in my D44. From what I've read that will require removing the ring gear from the carrier. Is it OK to reuse the...
As I was going to work today, I down shifted to 2nd as I was making a left hand turn and my T14 tranny started making a very audible clicking...
I picked up a T176 four speed yesterday. I pulled the top cover to check it out. I don't know much about transmissions, but I didn't see anything...
I have decided to replace my leaking T14 D18 combo in my '71 with a T176 D300 combo. I have a centered D44 rear to swap in as well. My Jeep sees...
Does it matter which brake line is connected to which port on the duel res. MC on my '71 CJ5? I'm replacing my MC and notied the old MC's ports...
Would it be worth my time to swap out my T14 for a T150? Is a T150 significantly stronger than a T14? The ratio's of the T150 seem to be better...
A guy I work with told me his son has an old Jeep for sale. I went by his house this afternoon and looked at it. It is a ECJ5 with F head, T98,...
I'm hoping to be able to replace my suspension real soon. My add-a-leafs are about to beat my brains out. I had narrowed my selection down to a...
Is this a "roll cage" (maybe aftermarket?) or did somebody get creative with exhaust tubing? I've never seen the front part of one designed quite...
For those of you running a poly gas tank mounted like the '76 and up Jeeps, where the tank straps to the skid plate, did you put anything between...
Can I use the mechanical fuel pump from an even fire 3.8L on my 225? I know I may have to change some of my lines, but the 3.8L pump is half the...
I'm in the middle of replacing my front brake shoes and realize that I'm missing a lot of the small parts, especially the self adjuster parts....
Does anybody have any info on a Holley street dominator intake #300-22? Is it for odd or even fire V6's? RPM range? I just won one on Ebay.
Does somebody know what the ID specs are for Dana 27 spindle bushings? I ordered new bushings from Krage and they are .012 to .013 bigger on the...
Separate names with a comma.