You are correct. I'm just saying that the 11 inch backing plate from the Dana 30 from was a perfect fit, with no modifications. Thanks, TAZ
Just to clarify... I used the 11inch brake backing plate from a Dana 30 front off of a 74 CJ. It was a perfect fit. The rear backing plate's...
I have a spare full floating axle off of a newer jeep that the axles and flanges are shot. The 11 inch brakes are in great shape along with the...
Well, I'm actually in the process of rebuilding my rear axle, 67 CJ5 Dana 44, off set rear end. To change the brake components, I had to remove...
Well, I purchased the offset D44 rear end. I got it installed, but now I've got issues with the drums being swaged onto the hub. The previous...
Thanks for the info. I believe I'm going to go ahead with the purchase of the 69 offset rear axle. It'll get me up and going; whereas, now I'm...
Re: VIN Numbers I own a 64 CJ5 with no VIN Plate. I only have a California DMV Number on it. It doesn't have the original motor or tranny. How...
What about the weaker 19-spline two piece axles? I'm running 35" super swampers, and I was worried about strength with all the HP that I'm turning.
I've found a 69 Dana 44 offset with the same gear ratio that I have for $125. I may just buy it and call it a day. I was hoping for the centered...
Well, I couldn't find any axle shafts to fit my original 64's offset axle. I searched around, and called several places. No one could help me....
Well, the Dana 18 transfer case has a longer front output shaft than the Dana 20. Can I just take the 5 bolts loose from both transfer cases...
I don't know about the history of this rig except that I bought it off a guy in Houston, Texas, and he bought it from a guy in Alabama, but it was...
The yokes are different from the Dana 18 to the Dana 20.
I think it would be much cheaper to use my Dana 20 transfer case, and lengthen my front drive shaft, as opposed to getting a double cv shaft for...
Well, it's not that the transfer case itself wouldn't fit. It's the shifters. They won't fit because of the transmission. The shifter mount on...
Is it just a matter of finding a CV driveshaft to fit in it's place, or are there other modifications to make for the CV to work? TAZ
Unfortunately, I've tried the Dana 20 transfer case, and it wouldn't fit because of the transmission. Plus, I have to lengthen my front drive...
I've found that the pinion seal isn't really that hard to pull. Sometimes, it is stuck, and you have to get some needlenose pliers to pull it out...
I own a 64 CJ5 with a Chevy 350 and TH350 Tranny. First off, I had to remove the offset rear end becuase the axles were shot, and the gears were...
Separate names with a comma.