Cool man! I'll check it out. Thanks, -Steve
Hey, When I got my Jeep a little while ago the accelerator pedal arm was being held to the carb with a zip tie :roll: I'd like to get the...
I just installed a pertronix in my 69' CJ-5 with a delco dist...super easy to install and I must say it works really well, my idle is much...
Well I finally got if off, it was definitely the lower winsheild mounting hooks, I took those off and tapped it from the bottom with a rubber...
Well I'm pretty sure its not the any of the cables, If it was I think it would be resisting in just the area where the cables are plus it will...
I do have the steering column bolts off and the windsheild is folded down, the dash feels real flimsy like its ready to off but there is...
Hey, Today I tried to remove the dash to fix up some of the wiring and do a little gauge diagnostics since non of them work.....I removed all...
Ahhh well it wasn't as bad as I thought...turns out the main wire harness connector came loose, I'm going to guess this is why the Jeep died also....
Well last night I installed a pertronix ignition, reset timing and adjusted the idle spped screw to get a steady idle, yay! everything worked...
Ahhhh, Thanks Patrick! I was not aware of that :oops: ...hopefully that will help a little, I definitely need to get a hold of the FSM ASAP....
Is there another screw for idle besides the 2 on the lower front portion of the carb?
Hey guys, Now that I have the drivetrain fixed up I've been working on getting her to run decent, or better yet just hold an idle. I've been...
That would be really nice except the flywheel is in the way.
Cool! Thanks again [IMG] . However I don't think I have that other mount?? I'll take a pic once I get it back together.
Thanks Mcruff! I slap that in there today, also when I go to put the trans back on is it possible to install the bellhousing/clutch fork and...
Hey, Well I'm about ready to put the trans back on with a brand new LUK clutch, adjustable pivot ball and pilot bearing when I get the...
Well I decided to just buy a whole new clutch, I also ordered a new pivot ball that is adjustable. I figure this way when I put it back together...
So you think I just need to get another a shorter pivot ball to make it work? Thanks for the measurements I'll check the pivot ball tomorrow, that...
Hey guys, Thanks for the input! That picture of the fork even had me fooled, I had to run out to the garage and make sure I wasn't seeing...
Hey, Well I finally found the time to drop the tranny on the CJ to fix this clutch fork issue the PO had told me about. It seems as though...
Separate names with a comma.