Something to watch for when searching for the cast manifolds is the drivers side. Make sure they're for a CJ because I "believe" they were a...
Does anyone have a picture to compare the right t/c vs the wrong?
Hey, thanks for the link! Nice write-up. So I wonder if a intermittent type motor would work as well?
Can a newer style motor be made to fit the intermediate style windshield frame without mods? I don't have a newer style motor to compare. Thanks!
I got all the pieces I needed last year for mine ('77 - early '78 donor). Hmm, lets see: caliper mount, hub, rotor, caliper, pads, flex line. The...
Just a thought, but a running 401 for $200? Buy it, decide later what to do. I think you'd maybe make a buck or two on that deal to put towards...
Just checked them, not adjustable. I see new ones listed and they're apparently the same for both driver side and passenger. Hmmm, wonder what...
I've just noticed that my CJ has a 10" and an 11" wiper arm. Is that right or is one from a different year?
No bids? That's pretty bad. I would have thought it would be snapped up. I looked for 6-8 months before I found one, and it's going to need...
Are the tabs on the back of the pad supposed to screw onto the top of the windshield frame (by the defrost vents), or on the side facing the...
Does anyone have a picture of how the dash pad installs on an intermediate CJ? I've got one with a sort of clip on the back (4 or 5 I think), but...
I'll try to get some pics tomorrow. The CJ is pretty much in pieces so I'll dig the tach out then post them up.
I have the factory tach in my '75 Renegade and the wiring does go through that hole. I purchased a '73 dash to replace mine (poor shape) and the...
Hi there, I'm mounting my lower windshield hinges to a fiberglass tub and wondered how they sit exactly? There's a bit of room to play with, and I...
Sounds nice! I've got a couple D18's I'm putting the internals into my D20, and plan on using the twin sticks as well. Did you fab your sticks up...
Hi Karl, Thanks for the reply. I would be interested. Is it the Pertronix ignitor I or II? Please send me an email to aqiaq@yahoo.com with your...
Shoot, I keep forgetting to put that! :oops: It's the 304, so unfortunately not the easy swap.
I'm thinking of finding a '72 to '74 dizzy to replace the odd '75 I've got. I'm not up to spending the big dollars (to me) on the DUI, Mallory,...
Actually I'm looking to buy a dash pad. I'll post over in the wanted section too, but after reading this thread I just mentioned it here.
Eeeewww, someone dug up an old thread! :D Oh well. I've been trying to find one of these. So, if you have one to sell, let me know. Doesn't...
Separate names with a comma.