Thank you for the responses. Very Helpfull. still thinking about getting the 10k lb, for future use, but as I said I'll never need to pull...
Hello I finally decided to buy a winch and after reading the manual I have a few questions. The background details. I do light off road,...
sent private message instead.
I'm still undecided, but there is a guy who is supposed to look at it sunday. If its still there the owner will be calling me monday. I have...
so I found a decent 66 cj down the road for 500. I have a really nice 83 that I had been restoring. so like potato chips I'm thinking you need...
I took the expensive route. Bought the jeep like everyone else it was old old an tired at frst. I got about 8-10 mpg. Over a year of issues, I...
Its just a single wire but so I could be wrong but it looks like the coil negative wire and or the tach wire if you have one. It goes back to the...
also if your not in the mood to search a junk yard I bought two new seat belts for mine from a place called rv and truck supply for about $17 I...
very cool. I don't know when your started. I have not looked at the board in a while. I started building a similar project a week ago. In mine...
I spent the morning messing with the jeep. I still don't quite understand the problem but I advanced the timming a lot. Its back up to 20 degrees...
Hi I Have a 2 month old motor(258) I had a hard time getting it running, had to set timming to 30 something degrees to get it to run...
Hi Question Why can't you use the same spot as the electical guage used to be? Does that have something to do with why my mechanical guage...
Re: Drilling\cutting fuid I used to work for an old machinist and he always used ATF. I have been doing the same for the last 10-12 years and I...
You don't need to remove the motor, but unless my motor mounts are not correct, you do have to lift the motor slightly. On mine the motor...
So I got my easy button... sort of. I got the jeep into the garrage and looked into my trans problems. Clutch and all linkage is fine....
Hi everyone. So I spent the last two days in the garrage working with the jeep and welder. I gave the jeep custom tool boxes, a new center...
If its not cranking at all its probably more basic than a computer. If your good with a multi meter I'd check for voltages at the...
last idea, Does your jeep have a fuseable link wire? Piece of red wire to the ignition that acts like a fuse. It works great then just dies one...
Does a 79 use a ford ignition control module on the bottom of the drivers fender? Usually when they go the engine spins but no spark. It would...
Did you replace the ignition relay? Did you try to jump the relay? A screw driver or jumper cable is great for testing it. Its a cheap part...
Separate names with a comma.