If anyone is is wanting to put a front bench seat in an early '5, or needs to replace an original seat but can't find one,this may be the answer....
I have the same problem in my "55. Thought it was a tranny or T-case noise, so had both rebuilt,the noise was still there. (Very loud gear whine...
Do you have a short in a wire, or a battery drain problem? (Two different things)
Just thought half doors would be alot cooler in the summer rather than full steel doors, plus help keep some of the mud out of the inside when...
I've seen ready made doors like you describe, made for TJ,s called "Safari Doors", just the frame work,not solid, they look good. But $$, 150.00 each.
Sure sounds like a bad ground.Clean all connections, run another separate ground if needed,just to make sure.Good luck
My 134 did the same after installing the Solex.A few things to check: fuel filter and fuel line,the filter in the carb itself,engine...
Not a bad idea,the fiberglass would add plenty of strengh to the plywood, and would make mounting handles and hinges easier.
Thanks Mike, they do look good but I wanted to go with steel or diamond plate alum.
Thanks for the info,just trying to get some ideas, a picture would be great.
Has anyone made half doors for an early CJ? I have a steel half-cab "55 I would like to put half doors on. I know there are several store bought...
The air cleaner is an oil bath type, the bottom is supposed to be about half full of oil. If the Jeep dies while driving, you need to drain the...
Would anyone out there have a fan blade spacer for aF-134? Checked a coulple of suppliers but no luck. Made one out of plastic but it's not going...
Sounds like a nice CJ. The gear whine very well could mean a T-case / tranny rebuild in the future, but all D-18's are somewhat noisy.What size...
It's a hydraulic switch, should be mounted in front of the M/C.Check the wires going from the switch to the lights,I had to replace them before...
Krage Motorsports has single action pumps with the glass bowl, (without the vacuum fitting) for 25.00. Or the double action without bowl.Send them...
The two holes in the gear are there for the puller 'ears" to fit into. Get a puller that fits, or you might have to modify one to fit. This is a...
Try a farm/tractor supply store.Saw some gauges there last weekend that Iwill get when my JC whtney gauges quit! Black,2", and built to last
You shouldn't necessarily have to replace the seal in the rear main bearing cap. If the rubber plugs were cut too short, or RTV sealant wasn't...
Is the steering connecting rod too long or the tie rod? I'm with Jason, if the tie rod really needs shortened, it's probably easier/ cheaper to...
Separate names with a comma.