Just bought some garage floor mat material at Autozone.....going to try an cut to fit....hope I can make it look good. Not sure how well it will...
Exactly...thanks. Didn't think about Harbor Freight. Will check Oreilly's too.
Wanting to custom cut a vinyl mat fornthe front floorboard for my'65 Tuxedo. The standard Jeep suppliers have various versions with different...
Thanks guys...good info. Yes, I was thinking about the pinion bearing as well....I can't detect any side to side movement, but I have not pulled...
65 CJ5 wihich now has a D44 rear and a D20 transfer case. Have had new clutch and pressure plate installed. Transmission torn down and inspected....
High teens for quick sell...low 20s if you have some time. Just my gut feeling.
None of the big 3 auto part stores here list a UC12 part number for a 12v coil. What vehicle can I specify that would have had an appropriate coil...
Thanks, but already have a new ballast resistor. Just wanted to make sure I bought the correct coil. The coils listed at autozone for the '65 CJ5...
May have fried my coil on '65 CJ5. Has been converted to 12v. Cannot find a ballast resistor between the ignition and coil. Should I buy a 12v...
Exactly!!!
Thanks Nick...don't really have a vibration issue as much as a "rattly" sound when in 3rd. There is no noise when transfer case disengaged and...
Yes...Dana 20 and centered rear differential. I'm guessing I prolly ought to go ahead and just buy a new front driveshaft if I can find the right...
Actually, this thing was just lengthened by our local driveshaft shop (part of my fiasco with the local transmission guy) It's a '65 CJ, but had...
Would this be the correct replacement? http://www.jeep4x4center.com/sliding-yoke-for-front-rear-driveshaft-909213.html
Laying underneath, couldn't get a solid whack to drive out the shaft. Broke out the air chisel and that drove it right out. Shaft and needle...
Perfect...thanks. Now if I can just figure out what to use to drive the shaft out
Is there a werbsite or link that will give the basic steps on replacing the intermediate shaft and bearings in a '72 CJ....I've got the Jeep...
Can it be changed without removing the case? Is #17 the part? [img]
Making sense...sounds like the transmission guy used the plug from the D18 on the D20.....I'm going to see if I can grind it down for clearance.
What's it for? Transmission shop replaced my D18 with a D20 and this plug is jammed against and denting the floorboard. Should there be a hole in...
Separate names with a comma.