No change with the tach disconnected. I will be picking up an adjustable vac advance to try. Some of the fuel lines are soft, I will be replacing...
Thanks for all of the replies, this should keep me busy this weekend. I'll update with any progress. Hugh
I recently rebuilt the Rochester 2g carb on my 1970 CJ5 with V6 (recent HEI installation), and am having a hell of a time getting the adjustments...
I set my hand throttle up with two brass cable stops. One acts as a cable guide (the cross hole was bored out with a 1/4 inch drill bit and then...
The connector on mine is a square with two male and either four or six (I am at work and can't remember the number off hand) female connection points.
I am currently getting the parts together to rewire the jeep. I found a sparton turn signal that I am rebuilding to replace the crappy plastic one...
Thanks for all the replies. I will be looking for a locker when funds allow, it looks like the best way to go.
I was changing the fluid in my Dana 27A (for the first time since I bought it), and found broken teeth in the bottom. the teeth matched up with...
I'm by no means an expert, but I installed this about a month and a half ago and it seems to have really helped reduce the freeplay in my...
Thank you for all of the quick replies, I'll rip back into it and retrace the wiring. I must have just gotten a wire mixed up. Are the SW marked...
I just installed a CRT HEI distributor, and now the tach is not working. I believe that I have this wired correctly, but if not, what should I be...
Separate names with a comma.