The problem is that the the top of the hood, fenders, and dash/cowel was sanded down to bare metal before and just rattle can primed. It wasnt...
I figured the wire wheel might be a bit agressive but figured id ask anyway. I do have a good 80gal compressor, but whats the advantage of an...
I understand the need to get to the bare metal if at all rusty, but what are some good methods? The rubber disk with the stick on sandpaper seems...
Im sure this has come up before, but I didnt find much in the search. If you know of a good post, let me know and Ill check it out. Im looking...
Thanks Mike! Sorry for the delay in responce, I have been out of town. Anyway Ill have to take a look into that for sure. Im realy hoping that...
Would any of you out there know how or if I can take the wiring harness from the doner vechile (4x4 Blazer) and just transplant it into the jeep?...
I keep hearing about the Holbrook springs, and Im sure their great, but Im really after that clean under the axle look. Maybe after more...
So I have been wondering what to do on my suspension. I like the idea of wrangler springs and they would work just fine for what i want to do...
How are you going to bring the headers trough the fenders? I would think you are just going to remove the inner sheetmetal, but that wouldnt make...
So I have a project that has pretty much been in the same state for the past 5yrs or longer. Its a 1948 CJ2A. I had good intentiones, like...
Ok, last question. Hot or cold rolled steel? I know cold is a bit stronger but it also adds alot to the cost of this and im not sure i really...
I vote for the Case Red/Black/Grey. It'd look pretty sharp...
I think I'll just leave the 1.5" high from the angle and then stack what i need on it and strap it down. I was thinking of having a 1/2" ID pipe...
OK here we go.... This is what i was thinking of doing to reinforce the carrier since the 1" ST is kinda small. Hopefully this makes sense....
Well its for the Wife’s Jeep Grand Cherokee, if it were for mine I’d just throw it in the back, but considering its still a work in progress.......
Jour most likely right. It was just an idea. What about an offset hole on the mount, I'v seen that before. Something where you can move it...
could i sleeve it lik you can do with DOM? maybe get the 1" ST and then a smaller 3/4" St to go inside it? I think i should be ok, 300lb of...
Well your right about it being hard without pictures but I do get your idea of the extra flat stock to help spread the load of the frame on to the...
So I want to build a small cargo carrier that fits in a 1” receiver. Mainly I’m building this as a welding project to help carry some firewood...
I went with the Novak mounts and they worked out great. My steering cleared ok and I am also running the TH350 so so need for clutch linkage. I...
Separate names with a comma.