The frame was in great shape considering how much the body had rusted out. The rear crossmember/bumper was the only rusted part. After...
The body is new except the grill. There wasn't enough non-rusted parts on the original body to even attempt rebuilding it. Apparently you cannot...
This Jeep has had an interesting life. VIN says it came with the 225 Dauntless, when I started taking it apart it had a 231 even fire Buick...
[IMG] This is where I am. I have removed a snap ring and I am led to believe from my reference book that the shaft should pull out, dropping...
Yeah, I have it broken down as far as I can. The bearings look good, so if I can't get the shaft out its not that big of a deal, but I have a new...
I am trying to get the steering column out of the steering box on my 69 CJ5. It is a Ross manual steering. I have removed everything from it...
Sweet! just what i needed, thanks fellows!
The crossmember in the photo was bolted directly to the frame. When I got the Jeep the PO had a 3.5 inch spacer on one side and direct to the...
Thanks for the great replies. I am buying a new tub and don't have one to work with right now. I do have the grill however. On this year group CJ,...
I am putting in a Chevy 350/t15/dana20 combo onto my '69 CJ5. The jack stands are under the axles, and the frame is level. The frame is attached...
13-07-055-901. It was bolted to my even fire 231 v6 but I don't know if it ever ran.
When I tore the engine down it looked okay so I already have too much into the Jeep to start fresh. I am leaning towards the 304 I just needed the...
I am in a conundrum and looking for suggestions. I was planning on a frame up rebuild of a rust bucket 1969 CJ5. Once I got it apart I found out...
I have been looking at new tubs online. It appears that the tub years go from 52-68, then 70-71. The '69 is made by itself. Anyone know what makes...
I have seen some pictures and am very impressed, but for me: "A man's got to know his limitations"!
I actually have trashed the body and plan on buying a complete metal body from kaiser willys auto supply. It was way to rusted to do anything...
It is a 231, according to the data I found on this fine forum, thanks for Joel Vande Berg for compiling it, it is a 1979-81 V6 Even-Fire Turbo...
My first attempt at rebuilding, I say go big or go home, so what could be easier than a frame up restoration! 1969 CJ-5, PO did some welding of...
While tearing down my new project I was looking to see if the engine serial number matched with the VIN. The VIN says the Jeep came with a 225. I...
Separate names with a comma.