Does anybody have a good place to call and get a carb for a 231 oddfire 1976. Going back to a 2bbl as the 4bbl is WAY too big for this little engine.
Been a while since I've posted on here but always lurking the site. A few years ago I had my axles rebuilt with powr-lok's and all new bearings...
[IMG]
i'm getting parts together for my cj6 build and have some questions. i have a '97 4.3 out of a s-10 blazer and will be bolting up a way older...
ok here goes. I will be starting soon on this build. please bear with me as the progress may be a bit slow. I have never transplanted a different...
still gathering parts for the sm465 swap. if i go the route of a 4.3 what flywheel should i be looking for? i have a chevy bellhousing with a...
i just bought a 1959 cj6. been wanting one for quite some time so i can have leg room. the seller said the engine was rebuilt (showed me the...
i have the pdf that shows how the discs are supposed to go but how do you arrange them to make it more like a posi?
looking at buying a t-18 (6:32:1) this is supposedly a ford case with the right inards to use on a buick v6. comes with a AA adapter bell housing...
looking to get some spare parts for the dana 30 powr-lok. anybody know of a place that sells the internals other than the clutches? by the time i...
not sure if this needs to be in the intermediate or the early so i will start here. i did a dana 30 swap in my '71 with a '74 dana 30 with '78...
So I decided to build front and rear bumpers Friday at work. The unfortunate thing is the wall thickness is only 1/8" on the tube but that is what...
I've been looking for a while for a set of 4:88 gears for my dana 44 flanged axle. after I bought a set of axles with 4:27's in them and swapped...
going to be installing the front and rear yoke seals in the dana 18 today. there are some felt washers in the new box. should i install those too?...
would a 2g carb from a '80's chevy 350 work on a 231? http://images.craigslist.org/00r0r_fu0bwsrATLq_600x450.jpg
i have a 71 cj5 and wondering if a ramsey pt1-j will be a direct bolt on? the unit came off from a 55 cj5.
i've been pondering the last few days about this. how well would a t-14 hold up to some serious wheeling with a tera-low kit in the d-18? I have a...
i just purchased a mojave heater for $100. it looks almost new and comes with a plenum and fan switch. hoping to rip out that sorry excuse for a...
i finally got the dana 30 into the '71. the question i have is when i get my degree wedges from mike what way do they go on? it looks like to me...
i bought this unit from a member here a bit ago and am trying to make sure it is what he said it was. i was told its a dana 30 powr-lok with a...
Separate names with a comma.