cookieman, did you use the gear that came on the dist. or did you put the one off the stock dist. on it? I'm hearing some of the aftermarket one...
Will this improve throttle response and performance at all and is it hard to do. I see that I can email them fir the instructions if needed.
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=350247239792&category=33690&_trksid=p2773.m263&_trkparms=algo%3DSI%26itu%3DUCI%26otn%...
Thanks for all the the info Guys.
Is there a 4spd. tranny that is a "bolt-in" replacement for the t150 3spd? I'm looking for a lower 1st gear.
I got it for $65. I bid on several on ebay, but most got over $100. I think the one I got is 15/16. I don't know if many guys use them, but I hope...
How can I tell if my '79 CJ5 is a wide or narrow track? Is there something I could measure and were all sway bars made to fit either? I just...
Looking for pics of where front sway bar mounts to the frame on a '79 CJ. I have pretty bad body roll in my CJ5. I'm sure the springs are...
Does anyone have pics of where the sway bar links connect? I'm guessing it's to the u-bolt plates. Is there just an extra bolts welded to this...
The fan is a direct drive. Thanks, I found a shroud on Ebay. I'll give that a try. I also bought a mechanical temp guage today at AutoZone for $20.
I didn't know that CJ's had fan shrouds. I looked for a new one online and couldn't find one listed anywhere. I can try replacing the cap.
I installed a fresh 304 in my CJ5. The old motor didn't have a thermostat, but I installed a 190 in the new engine. Used the same radiator and...
Thanks guys, now I have to figure out if I should buy it or not.
Thanks, I'm looking to put a 4spd in mine, Is there a lower 1st in the T-176?
Ok, I have a 79 CJ5 with a 304, t-150 3spd and a model 20 transfercase. I have an oppertunity to buy a parts Jeep 81 CJ7 with a 4 spd, could be...
Thanks, Guys. I did check the spring and piston, I thought the piston slide smoothly. Its only $20 bucks at NAPA for a new gasket, spring and...
I think I may have found the problem. I don't remember seeing this hole in the new gasket I got from NAPA yesterday. I think this would restrict...
The Vaseoline in the oil pump was the fix and the oil filter does have the valve. I stuck the distributor back in and it fired right up. I watched...
Is it not possible to cut and paste photos? I was going to post some pics of my progress, but I can't seem to paste anything.
Thats what I did when it was on the engine stand and it worked well. The guage on the dash has always worked good prior to the new engine. I think...
Separate names with a comma.