5/16 it is then. Thanks for the input guys.
Ok, I'm trying to replumb my 3b. The previous owner had all kinds of Frankenstein line of various sizes and compositions. Heck, he had part of...
Well, I gotta replace my tank. I've been looking around and notice that the aftermarket people offer tanks for "early" 3b and "late" 3b. Since...
Most of the tires they sell are usually made by either Cooper Tire or General Tire. One way to tell it its a "made by Cooper" is to look for a...
Dont forget about Snap-On, Mac, or Matco. Craftsman might even make one.
I found the article you guys are talking about. It is September 1988 Four Wheeler. The article name is Trail Buddies. I would post pics but I...
I used header wrap on my p/u. The stuff does work. However, when I removed the wrap to replace my block huggers with manifolds, I discovered that...
Bob, if you have any problems finding a good muffler shop, PM me. I know a couple places up there that do DARN good work. I know, I worked at...
Just curious, is this seatbelt DOT legal? I have a group of friends that are drag/street racers and have been cited for wearing their 5 point...
VHT makes primer as well as engine enamels. You can but VHt stuff through Summit catalog
Hmmm... cannot make up my mind on this one. Should I run with the parking brake setup on the Dana 18 transfer case or should I use the setup that...
Well, I gotta get a diff for my dana 30 front axle because of the ratio change. I've been thinkin'(ouch, painfull) I might as well spend the extra...
Are you running anything electronic?(MSD box, fan, fuel pump, amps, etc..) Like I posted earlier, I ran into the same problem with my truck. The...
Good luck Patrick. I went through this same stuff with my '63 chevy P/U. I actually carried a second battery with me just to jump the truck. It...
You can try removing a cable off the battery. And while you have the hood open, pop off the coil wire and take it with you. If you are running an...
Just curious, are you sure it needs 4 drums all the way around? I would have the drums checked first before ordering any new ones. That would save...
Thanks for the input guys.
I have been reading other current threads on the AA adapter SM420 to Dana 18. I notice that they seem to be having problems with the location of...
You might have to check with your local muffler shop on that. There are several manufacturers out there that do make complete exhaust systems for...
I got my seals for my manual saginaw box from LMC Truck (lmctruck.com). Both seals run 8.95 each. The bronze bushing was 16.95.
Separate names with a comma.