I use wheel bearing grease as well. I also use it as an emergency back up seal in case my tractors pto takes a hit out in field while running my...
I wonder if the rotor is mounted 180 degrees off. I know there is a square and round holes to locate, but I'm just wondering. Could you shoot a...
I used bondo on my Kubota ag tractor hood. No cracks after four years and that hood shakes and flexes like nobody's business.
I was just kidding about rusting out an ammo box. I think the idea is cool but wonder if the weight may cause the dash panel to distort?
Lots of great ideas here. I still have some cardboard left in my box! I was thinking of using heat duct or sheet metal to create a floor and...
Ok, thanks. I don't know if I should change this mount set up. I guess it will depend how far I get into it. Suppose it worked fine for PO. I took...
Looks like PO made up the mount at the frame with a bolt welded to a plate that he mounted to the fram. It's just not square is all. Ok well I...
Oops, I meant the clutch shaft is more rearward at the frame than the TC. Posted via Mobile Device
Posted via Mobile Device
Hey thanks. The mount under the trans to the crossmember is thru 2" square tubing. Could this be the issue? Maybe they relocated the crossmember...
What else defines this as a t90? Posted via Mobile Device
[size=1]Posted via Mobile Device[/size ok. The side of the trans says T 86aa
I was wondering if anyone could tell me by looking if I have a stock trans adapter? Seems like PO has mounted trans to frame an inch rearward....
I think it's plenty strong, the neck flange is massive and the tank is probably safer than a metal tank. I just think they aren't the most...
Can't speak to the tabs issue but I did have a few problems both with MTS and 4wd hardware, where I ordered it. I'm not too impressed either for...
Yep.
Don't want to make you mad here I just feel like adding my two cents for what it's worth. I am new to this site and have gathered an opinion that...
Ok. Just got off phone with MTS and he said 4wd orderded the wrong tank. The o-ring tank has a pickup built into the sending unit and is 5/16. But...
This is an aftermarket tank. There is a 1/4 barbed fitting that has the attached tube inside of tank that goes to the bottom of the tank. There is...
I was wondering if anyone can tell me if my new plastic tank is going to supply fuel to my v6 properly. I bought the Jeep without a gas tank. I...
Separate names with a comma.