No, you need it on the bench to get it apart. There is a snap ring holding the output gear on the shaft you have to get off before the shaft...
I have had good results using the tool that Eastwood sells for making double flares on steel or NICU tubing. Beware trying to flare stainless...
I once cut the dash welds on a customer's Jeep, then used bolts to re-fasten the dash. We had to remove the dash to put in an overhead swung pedal...
I went to the hardware store and bought a masonry chisel. It had a blade about 4 inches wide, and I cut a 'U' shaped notch in the center of it big...
Focker, (and anybody else interested in this) I have opened up one of these Crown MC and looked at the bore size. It has a straight 1" bore for...
Hmm, valve train noise. When I first looked at the Yellow Barn Find in the owner's driveway, we got it to fire up briefly and it had a couple of...
Separate names with a comma.