1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Pcv Valve Connector

Discussion in 'Early CJ5 and CJ6 Tech' started by Don X, Jul 27, 2021.

  1. Don X

    Don X The Prodigal Moderator Staff Member 2023 Sponsor

    What is the proper name of the connector in the pics below? Does anyone have a source or P/N? Thanks.

    [​IMG]

    [​IMG]
     
    Don X, Jul 27, 2021
    #1
  2. PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Last edited: Jul 27, 2021
    PeteL, Jul 27, 2021
    #2
    Don X and scoutpilot like this.
  3. Steve's 70-5

    Steve's 70-5 Active Member

    Reducing Bushing
     
    Steve's 70-5, Jul 28, 2021
    #3
    Don X likes this.
  4. Don X

    Don X The Prodigal Moderator Staff Member 2023 Sponsor

    I checked with Mike at Kaiser Willys. He said he doesn't carry it but that NAPA will have it. Just tell them to look in their Weatherhead book. My PCV is 75 miles away and I don't know what size the fitting needs to be. Does anyone here have one on which they can check the thread sizes?
     
    Don X, Jul 28, 2021
    #4
  5. Glenn

    Glenn Kinda grumpy old man Staff Member

    Is your's setup the same? I originally was thinking 2 different thread sizes but maybe not....maybe 1/8" pipe, maybe a 1/4"? Pipe shows up easily enough, but the PCV side is dark so it's hard to guess.
     
    Last edited: Jul 28, 2021
    Glenn, Jul 28, 2021
    #5
  6. PeteL

    PeteL If it wasn't for physics, and law enforcement... 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Technically a bushing has external (male) threads. This is female at both ends.
     
    PeteL, Jul 28, 2021
    #6
  7. Don X

    Don X The Prodigal Moderator Staff Member 2023 Sponsor

    Here's my PCV. I'm trying to figure out what size reducing coupling is needed or the left end of the valve.

    [​IMG]
     
    Don X, Jul 29, 2021
    #7
  8. Rick Whitson

    Rick Whitson Detroit Area 2024 Sponsor 2022 Sponsor

    Don, couldn't you put a 1/8th nipple and a 1/8th to 1/4 coupling then the PCV on it instead of two elbows? Do you have Vacuum wipers?, Just a thought.
     
    Rick Whitson, Jul 29, 2021
    #8
  9. Glenn

    Glenn Kinda grumpy old man Staff Member

    I know, me too. Looking at this picture again I'd say 1/4". I agree with Rick's idea too.
     
    Glenn, Jul 29, 2021
    #9