62 Cj5 Warn Locking Hub

Does anyone know where can I get parts (bearing, center spline) for these hubs? One of the bearings is shot and the center spline for that one is badly pitted as you can see. Thanks!

 

After sandblasting...

 

I don't think you will find the center spline except trying to buy another unit for parts or using yours as parts. Over on the OldWillysForum there has been a discussion including someone that made and now sells the previously unavailable dial O ring. Gaskets for Warn M2 hubs You will also see a guy named Greg who goes by digger that will have some old hubs you can buy.

 

First picture bottom left the hub looks like it had A Torrington needle bearing , should be A part number on
the outer edge . should be able to get @ any bearing supply .

 

These hubs come up frequently on eBay, both in singles and pairs. They are one of the more common styles.
-Donny

 

It does have a Torrington, good eye! The problem is that it was really chewed up and illegible. I looked at the other one that is ins better shape and I found the trade number. Is a Torrington b-228.

 

Any specifics to look for to make the search more accurate? I just don't want to order something that looks similar but is not. I know is a 10 spline, but that is all, folks!

 

The thread I posted has it. Jessie at Torque King 4x4 has the O rings, gaskets, bearings, etc. , in a complete kit or standalone. I'm no expert, but that center piece is just going to be a problem if it even works. It is chewed up and rusty. The pins slide up and down that as it engages. I doubt it will be able to slide easily. From the looks of it, it was pretty abused over its life.

 

Torrington sold out to Koyo still the same number , 1-3/8" ID x 1-5/8" OD x 1/2" Wide .
Amazon shows them , NAPA or Rockauto May have them also. ( Koyo B228 )

 

Thanks!