1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Stock height shackles...beating a dead horse I know...

Discussion in 'Early CJ5 and CJ6 Tech' started by 68BuickV6, Mar 24, 2013.

  1. 68BuickV6

    68BuickV6 Well-Known Member

    I did the same.

    A large "C" clamp and a craftsman socket was all I used to press them in.

    Dig that no rust California Jeep. fb
     
  2. rcassettyjr

    rcassettyjr Member

    Cool. I have all the bushings sitting in the freezer and I am going to clean out the spring eyes and shackle hangers with some sandpaper then warm them up with the mapp gas torch so they should not be too hard to tap in. Hopefully the weather is good tomorrow and I can get them done and get back to having a rolling frame.

    Thanks
     
  3. oddfirejeeper

    oddfirejeeper Active Member

    ok.... so stock length shackles are 2.75"? is that bolt hole to bolt hole or total length of the shackle? i'm wanting to get a set from mike and wanting to know the right way to measure to give accurate measurements for him to make mine.