Couple things for sale T86 transmission in good shape, ready to drive. $350 Dana 44 carrier and gearset in very good condition. 4.10 ratio....
Looking forward to getting more involved here! I bought this keep when I was 17 (back in 1997) and I’ve had it for 25 years. I’m going to start...
Hey all - first post here. I have a '69 CJ-5, Dauntless, T-14, D18, OD w/ stock 4.88 and a Powr-Lok in the rear. The Powr-Lok decided that all...
I have a 1965 cj5 with a 44 rear end. I would like to install an air locker but need it to be 30 spline not the current 19. Is there any...
When I disassembled my Dana 44 these small parts fell out. The power lock has a two piece cross shaft with a hole through center - I'm thinking...
I finished replacing the pinion bearings on my rear Dana 44 and following the instructions of metalshaper, I set the rotational torque at 15...
I am in the process of rebuilding my rear Dana 44 tapered axle diff and I has bought (or so I thought) all the seals. As I was ready to install...
I had a post on here from a month or so ago about this axle but in that one I misidentified it as a 72. I confirmed with Dana Aftermarket that...
Are the u joints in the front and the read driveshaft the same P/N? I have a D18 and a Dana 25 and a Dana 44. Thanks!
Hi, I need a good rebuild guide to do my rear axle. Also, if anyone have the part numbers of the bearings and seals (shaft seals included) would...
I have recently acquired a 1963 CJ5 with a 1969 Dauntless 225 ci V6. It has a Dana 44 rear end with a solid, 1-piece axle, full floating. On my...
Other than opening the pumpkin cover, how can I know the gearing on my dana 44? Thanks!
I am using a 44 out of (actually still in a) '73 DJ5. I am replacing the axle bearings and seals, changing the gears, and rebuilding the trac...
1969/1970 Jeepster-Commando rear Dana 44, centered axle with tapered shafts and separate hubs, also has a Power-Lok. I am in the process of going...
Separate names with a comma.