I have had a welder come and cut out 16 in of bottom plate and cleanup the mount. All putt back together now. I thought of the Saginaw box but I...
[ATTACH] [ATTACH] [ATTACH] What I have here is a complete mess that I didn’t notice when I put in kit for bellcrank. The bracket that receives the...
[ATTACH] [ATTACH] [ATTACH] 1st try at sending pics with new app on I- phone Disassembled front shaft and then finished
HI again, redoing front ball joints and u-joints on my 67 Jeepster conv and have found out from another post that I read that my axle is from a 72...
hey everyone, problem solved .We followed Junk Wreckers advice and ground down the weld a bit more and tapped it a few times and off it came....
Got info from Jeepster Commando club that the postal jeeps have a similar wheel
Hi , not sure about the epoxy fix as my wheel has lots of chips on the inside hub. So much material missing, not sure how to replicate that part....
Hi everyone thanks for all the info. I found a bearing at bearingscanada for $28 CAD tax and shipping in Hi guys , thanks for all your info. I...
Do you remember how much it cost to ship to BC. It’s dumb that they would want duty on a used auto part. What do u want for your shaft. My buddy...
Would you part with it, and is it from a standard or auto if they are different. Mine is for an auto TH400. Will try tapping the yoke to see if it...
Hi guys thanks for the replies. I talked to a driveline shop and they said they probably couldn’t just cut it and weld back together without it...
No , I have the 2 piece driveshaft and on the front shaft is a pressed on carrier bearing to keep the shaft away from the auto tranny pan. I tried...
Hi I’m trying find out how to replace the bearing on my 67 Jeepster front shaft. Have ground down the weld by the u-joint and can’t see where the...
Separate names with a comma.