I have installed two different Flow Kooler pumps. Neither of them made any difference whatsoever temp wise. I think they actually pulled the...
Very common for the thin lip on the shaft to break and have the bearing stick inside the planetary housing. I have run several just putting it...
The yoke is almost always the biggest problem. They are cheap and easy to change.
The dead giveaway to be a Texas 300 is that there is no bottom bolt hole in the texas pattern. Super easy to spot. Yes you do need an input gear...
3 cents a pound
These really are one of the best gas motors ever built torque wise.
If you pull cable every weekend, go synthetic. If your cable has been spooled since Carter was president, stick with steel cable.
These really only need about 15 lbs of torque. The caps are actually easy to overtighten causing pre mature failure of the joint.
Not sure if this would actually count as being installed but it does appear to be in backwards too.
There are two different gears for the stock Jeep turbo 400 adapter. Both of them are 26 tooth. So you can run any 26 tooth transfer case behind...
Pin as mentioned above.
Lots of potential there.
Separate names with a comma.