Big thanks to Mike (aka sgogpn) for the rear backing plate. Richard also helped, but unfortunately he had a 10” plate.
Thanks Richard, will do.
Looks like I need an 11” backing plate after breaking my axle and dragging the backing plate on the ground. Just need one in good shape.
Looks identical, luckily it didn't happen at 55mph. Snapped in 4 Low on a trail
Broke the driver side axle recently. It broke at the thickest part next to the hub, so kinda thinking it was already cracked. Drove a few miles...
Rich Cain, I copied the Advanced Adapters chain system. You can see my build with part numbers here. Couple thoughts...I liked the set up and it...
Updated the design a bit. The built in reservoir makes it difficult to service. Not sure why I went with that design to begin with. I ordered a...
That's the build, thanks John...still a work in progress but at a slower pace.
Upgraded the shifter boots today. They are made by Stronghold Shiftboots and so far I am really happy with the quality. I have a T-18...
Finally got around to installing a new windshield glass. The old glass was pitted from welding/grinding sparks and the seal was in bad condition....
I made a custom hydraulic clutch set up. Might give you some ideas. Works well, very happy with it....
Pete, you actually made me lol... Chris, I spent about three hours watching videos on this little guy. I have a Hypertherm as well, so that part...
Go electric! https://pertronixbrands.com/products/pertronix-1165-ignitor-delco-6-cyl-odd-fire?variant=31797175058468
Separate names with a comma.