The hard part is done.
Thanks, that’s the switch I’m going go with, the Chevy truck mechanical one. I had seen that solution before on one of the Jeep forums, forgot...
Hey guys, my hydraulic brake light switch quit working again on the ‘46 2A, it was replaced a little over a year ago, not very many miles too.
Would the boot in this thread work?
Questions On Redesigned / Upgraded Clutch Linkage
A little late, but for your rods between Heim joints you could always get some Cold roll steel rod cut to appropriate length and run 1/4” - 28 or...
I prefer using test light to debug problems like this, the smaller ones can get into tight spots. Good to have in toolbox. Check to see if there...
Took advantage of 50+ degree day and painted Willys, now final wet sanding and assembly.
My 2 year old grandson helping prep for paint. He’ll be a Gearhead growing up, he’s always in my Jeep or on workbench.
I rebuilt my frame horns last spring, here’s the drawing I used. Came from the 2a page.
Project "Bam Bam"
Supposedly Fuji Filters has one that will work. The filters are not paper, they can be cleaned and put back into service.
I agree, a glass fuel...
Picked it up at estate sale down the road for $2.50, didn’t know what I had until home and cleaned it up. With 3 filters in system don’t expect...
Added vacuum gauge to 2A
Cool! I’m going to have to place an order now.
Separate names with a comma.