Those are very rare. I have been looking for one for years unsuccessfully. I have seen some Mahindria "Roxor" ventilating windshields on Ebay but...
From what I read if it is charging over 12v at idle and over 13 at higher RPM the alternator is working, and you said it runs with battery...
New pistons, and hardened valve seats, are usually part of a rebuild anyway, so that is no reason to "move on". What Pete says is true. New...
It probably is rebuildable, valve seats can be resurfaced or replaced, cylinders can be bored or sleeved if too far gone. That said nobody can say...
I did not check to see if the manufacturer had recommendations other than standard practice, but I reckon I figured it out the hard way. Lessons...
"Once again... "if it ain't broke, don't fix it?" " But when it is broke, you got to fix it?
Sounds like you may have missed the point of the two last posts. Ken and I both used the same brand of head gasket, both followed the manual, and...
You might be onto something here Ken. I used one of the Best copper head gaskets on my CJ5. I ran it up to temp, then re-torqued the bolts. Ran...
I have bought tools from Harbor Freight and most have been just fine, and yes if you break one just take it back and they will replace it, and at...
I missed that, sorry. I went out and got a box off the shelf and yes it does have that spring clip.
Nope, looks just like the ones I buy. Blue Streak is a good brand. What makes you think a part is missing?
Are you talking about tools for the shop, or tools for the trail? The Military tool sets, for onboard carry, were pretty sparse, and that kept...
X2 on what Pete said. "since they are new" does not always mean they are good. Something isn't right with one of these "new" parts. If you are...
"If my head is screwed on properly.." I realize you weren't talking about the engine head, but nonetheless this reminded me to remind you that...
It isn't just the strength of the bolts themselves either. The flange being held tight against the flywheel, the two pieces clamped together with...
Separate names with a comma.
