I like to rule out the easy stuff, Make sure your OP gage working and is correct. If it is, then it almost has to be the pump. I've always...
Hi, I just found this post and I'm interested. I'm in the process of going through an 02 VW TDI diesel to go into mine. I'm looking forward to...
Thanks. They look like SS. I bought a shrinking wheel kit from a metal guru a few years back and it works great. There were 2 sizes, I've only...
I have 6 of the Kaiser hubcaps, a couple are nice-ish. Most have dings. I've restored SS trim to new condition by slowly working it with small...
I would just buy any old Chevrolet passenger car TH400, and build a replacement transmission for the Jeepster with the adapter and output shaft...
Man, I'm in uncharted water. I'll talk Jason and get his advice on how I should proceed. Look how much easier this would have been If I'd been...
I was wondering if I could use my D20 on another GM trans. I'm a Mopar guy and know a lot of that stuff in my sleep. (kinda why I stuck to it.)...
No. This is getting out of hand. I wanted to be able to switch back to stock motor/trans if The notion took me. I'd be way ahead to just pull the...
OK. I've gotten some bad info and ran with it. Are you saying that the rear of the buick V6 in my JC is the same as a chevy 350? I found this,...
I want to do a TDI conversion on my 67 JC. The pre made adapters are from TDI to Chevy TH400 but Jeep used the BOP TH400 so only the bottom bolt...
Separate names with a comma.
