I contacted American Collectors through USAA and one thing they mentioned to me was that if the Jeep was ever going to be used on a "trail" or...
After watching that video, for me I'd hate to do a lot of work, spend a lot of money, and a year or two later watch it come up in sheets. It'd be...
Crap, I bought a body from Willys Overland, wasn't planning on stripping all the primer, but I guess I'm gonna have to now.
I guess I should have looked at the photos of when I took it apart last fall. Thanks for your help
[IMG] https://photos.app.goo.gl/J212rKNi1J6pqi6c9 Any idea why the previous owner would braze this onto the timing cover?
Thanks Everyone!
What do you think? Replace or OK? It's roughly 3-4 teeth that look like this on each, I've shown the worst. 1st /rev by Michael Toews posted...
Main shaft
Thanks a ton! With your help, I think I can figure it out now.
OK, I pulled it apart to check start from scratch, and I have a question: Does the bell that holds the felt on the yoke fit into the housing?...
In these directions, it has a photo of checking endplay and shows no yoke/flange installed. This is how I did it. The Novak Guide to Rebuilding...
Separate names with a comma.