I striped my tub completely down and hauled it down to Maaco and cost $600...that was changing the exterior color, and then painting the inside...
JcWhitney...same as above though...had to fabricate some of them, especially up by the master cylinder, otherwise they worked great!
I run 175-180...
I run around 40psi @ 50mph.
Where do you purchase this kit from?
What is the chain kit?? Benefits?
Another quick note on shackles....can't have them with to much lift or you extend your shocks to their limit...that happened when I put mine back...
I put a ProComp 2.5" lift, and it came with the U-bolts (the correct ones, even the odd one on the front passenger side), rear shims, shocks...
That oil is more than likely from your t-case leaking out of that seal. If that second pic is your t-case all cleaned up, I would recommend a...
I wouldn't bother with saving any of the old wire...if you get the one from EZ you will have everything you need + some...I save the extra and...
I agree with you, thought about shopping around for a different one, I'm 6' tall and have the same issue. Need to also get a little smaller...
It's does...check out my album, I just restored it last year and had it painted (just a Macco paint job)...pretty much blasted every part...
Like this one?? Not sure where my dad got it, he bought it (the jeep) brand new back in 67, rolled it over at some point pretty early and when he...
I agree...I did the same thing, actually some of my body bolts were already missing, so I just pull out the torch for all of them except the one...
Thanks...I agree with you on the EZ wiring harness...that's what I did, cost like $150 pending how many circuits you go...easy install, everything...
Separate names with a comma.