Hi, thanks for the replies, greatly appreciate it. @sterlclan, your rates sound pretty good and I'm looking for someone with experience. I will...
Hi all, I'll be short and to the point. I need someone to take my CJ6 project out of my garage, slowly get the tub back into a condition where...
Hard to say what the thickness of the rear trans mount should be. The AX15 mount is only about 3 inches thick, as is the trans mount for the t-15...
If there should be an angle, then i'm too high. I'm sitting dead flat, put a level on it last night. tilting down will hep with my transmission...
Hi, I've got some questions on transmission and t-case clearance. Background, I'm putting a 4.0, AX15, Dana300 on my 75 CJ-6 frame. The tub is...
1. My plan for this rig is a 2.5 inch lift, probably 32s or 33s, and to run light trails with it and do some fun family camping. It won't see huge...
Thanks for they reply, I guess I hoped a ping on his thread would get him active again. My plan is to buy a new steering box. There appear to be...
Hi all, sorry to resurrect the dead here but this is the most complete/recent thread that I could find. Mazinger, I'm looking to install PS as I...
Hi all, thanks for the quick responses. Zilla, when you called RR, did they say there was any reason to put one set of springs front or rear? I...
Question: I'm hanging springs as I move forward with this conversion and I'm curious if it matters which spring packs go where. Rocky Road sent...
Wow. well, i'm turned around on my setup and really excited to get it back on the road. Thanks everyone for the all the helpful input, greatly...
Thanks again for all the great comments, this has been very educational. I've not had this jeep for long and dove into a necessary suspension...
Mostly concerned about engine speed when traveling on the highway. I know that the 3rd in the t15 is 1:1, just wondering if that doesn't leave me...
Separate names with a comma.
