Putting new floors and cab supports in my 64F100. Mike E5D5AAAC-0AA5-4947-8824-0B45ED19DAF8 by BadGoat posted Mar 23, 2023 at 10:49 AM
I used two smaller fans to move the fan motors away from the center of the engine. This helped with the clearance. I don't have a fan shroud,...
You can put the intake behind the dash, lots of hardcore trail rigs do this. However, it is very noisy. I need to do an update video on the...
I ended up shaving the the back of the headlight buckets in addition to the grill shroud. Then I used a set of cheap super thin LED headlights...
Steering and cooling systems were the trickiest parts of mine. The LS motor mounts and the shorty headers don't leave much room for a steering...
I did mine by myself, so you don't need two people to do it. The u-joint does not hold the bushing in place and the shaft can be cut more than 1...
I like that you kept the old speaker grill. Mike
I I don't know how much travel it has on the splines. They just wanted the measurement at ride height. I'm also using a Dana 18, but haven't...
The length of the pitman arm should be approximately equal to the distance from the center of the ball joint/kingpin to the center of the drag...
My double cardan driveshaft from Tom Woods is only 14 1/2 inches long. It works just fine, even with the LS providing way more power then the...
I'll add mine as well. I converted my bell cranks steering to power using the following. Advanced Adapters conversion kit to allow use of the...
Separate names with a comma.
