Inertial air separation. This is why oil bath are superior to paper filters. Same principle in helicopter engines and many turboprop airplanes....
try high temp lab metal to fill to porosities. Hi-Temp Lab-metal
"Ran when parked."
Called a "Gits" oiler.
You are correct, just sheet metal screws that hold the main bucket to the grill, 4 screws with star washers. The ring that hold the bulb to the...
I believe there is only one spring and two adjusting screws. The screws are reproduced. The 'nut' that the screws go into is nylon or plastic...
Sorry for the repetitive posts. To remove factory installed rivets, the easiest way I have found is to use your cut off wheel and cut an "X" in...
Try searching 'willys imitation rivet bolt' on Ebay, several articles on them on other jeep forums. Mullins Jeep Parts reportedly sells them as...
As far as I know, the fuel gauge is a 12 volt unit, fed from a keyed ignition source (I) .the sender feed (S) uses variable resistance from the...
Hey, SW refers to the Stewart Warner original gauge. That is what I am using for fuel, the temp. Is one of the aftermarket ones from crown.
Been following this thread, as I have similar issues. My solution was not to wire in the 7806. But to use a sealed DC to DC converter, [Amazon...
Rick and Glenn, thanks for the info, advice and suggestions. I will certainly do a mock up before burning it in for good. My fenders are...
Okay, thanks for the info.
Howard, that is very helpful. Looks like the Lincoln wrench took most of the plate that aligns it with the front cross member. That will be easy...
Hello All, I am in the process of bringing my 57 CJ5 back to original. I just sourced a CJ5 battery tray to replace the late model firewall...
Separate names with a comma.
