How did the ebay carb work out for you? I saw where they have a weber kit as well and was wondering if anyone has tried it. Redline Weber...
I called around and found a local shop to do a full rebuild for 1600. I only have an engine lift and never been that deep in an engine. I thought...
Daryl, That is exactly what I am seeing now. I guess it's time for a complete rebuild!
Autozone refunded the felpro intake manifold gaskets, I ordered the Victor brand. Since I'm waiting on the new part, I pulled all the brand new...
Vacuum ran 20 with a small bounce before the intake gasket was replaced. I can get it to 18 max after. I took the manifold out again. Feel pro...
[MEDIA] Sounds like it's running lean, Maybe take the intake out again and use silicone, I used the dry felpro gaskets. [MEDIA] Looks like it...
I already returned the prestolite distributor for the core. I don't think that's it, I'm on the third distributor and same problem. Waiting on...
Oreiley's tried to give me a distributor with the wrong casting number, then Oreiley's said the casting number didn't matter. I quickly pointed...
timed one tooth back from the 5 oclock, had to turn the distributor to get it to run and match the #1 on the cap, no change... Can't go any more...
Back to timing! I put it at TDC marked my #1 on the distributor, Oreiley's dist 30-1611, Says 1110376 on side. BWD Rotor # D146 and CAP #C175....
Walt, the more I thought about it last night, the more what you said made sense. It would run 80 MPH last year. I decide to remove the carbs...
Tried pouring MMO down the carb with choke slightly pulled to keep the rpms up. Got some nice white smoke. No change. Replaced the motorla...
I think you may be right on the sticky valves! I replaced one at a time, resistor and coil, no change. Meausred old accell 8140 coil next to new...
Has anyone noticed that the resistors for prestolite and delco have different part numbers? I'm going to pick up the bwd delco resistor and a new...
It ran ok last year. Enough to hit 75 mph easy. It had a miss and idled rough. I had the prestolite in it before so I thought I needed points, cap...
Separate names with a comma.
