Will do! Thanks!
Hello all, another dumb question. The fuel sending unit on the 6-gallon cell under the seat has only one wire(sending). Is there supposed to be a...
Thanks guys! I worked out a little experiment with the float. I pulled it off, stuck the rod back through it and held both ends between my thumb...
Nobody has that brass float in stock...shocker. Plus it's a GP Sorensen which I have heard bad things about. I am at your mercy Sir. The...
That float was already inside the carb and my rebuild kit didn't have a new one. The instructions don't cover that funky float design just the...
Funny, I thought that about the bolts when I was checking the new gasket to make sure it fit. Just to clarify I wasn't actually drilling out the...
So, I was trying to do this Carb rebuild on that 2G stamped (GM) 2-Jet with the plugged holes of carbon but it has one of these Nitrophyl/plastic...
Thanks! Does the hole bottom out and another hole come in from the side wall? I started using a hand held drill bit to scrape out the crap, but...
225 V-6 Intake Manifold Vent Holes? Thanks for all the help guys. I think I need to just stop with this Jeep that's not even mine. I'm trying...
Anybody have an explanation for this? Long story short the temp gauge pegs out upon turning the key after a few seconds. Fuel gauge is out I...
Thanks for all the welcomes and all the advice! It seems that the clutch/brake assembly was so caked on with old dried up grease that it was...
Separate names with a comma.
