I pulled the the cover and looked inside. Like I expected the shaft moves but not the shift fork. I dropped the transfer case and cleaned the...
So, I was moving the 58 into the shop bay when the hi-low shifter fell back toward the passenger seat. The transfer case went to neutral. I moved...
Check out www.madelectrical.com and then electrical tech drop down lots of good advice and information.
Thanks everyone !! I will order one from the jeep Guy.
Hey Warloch, did you ever make some the bell housing inspection plates? I could use one for my 58 conversion. Otis, did Nic get you a outline for...
I have the same problem just reversed. I have a set of 79 heads and 75 manifolds. The ports are high on the head and the manifold drops a 1/4 to...
Thanks Wheelie. I have a new odd fire v6 sitting on the engine stand and a sm 420 on the floor to go in after the hunting season is over. That is...
I had a head gasket blow today. I have a gasket coming for tomorrow. But I need the torque for the head bolts. Any one have it ? I am working on a...
Now that is cool !!!
Tomato, Who makes that adapter .
That is good to hear Bubba. I have been a little worried about it...
Yep, My V6 is at the machine shop and I already have a rebuilt Sm-420 and Dana 18 married with a Novak adapter in the shop. I tried to get the...
Nice !!! What is your setup, trans-t-case-overdrive-gears-tires Ect. My V6 is at the machine shop. I hope I have similar results when it gets...
Separate names with a comma.
