I don’t think there will be an issue with rtv going through the engine. I am more concerned with any rtv remaining in the rms channel causing a leak.
Thanks Tim
Thanks everyone. I’ll try the pipe cleaner first. Is there a solvent I should use to help break the rtv from the block? I’m having a difficult...
Yes. I ended up pulling the cap and found that it is the rms leaking. The problem I have now is that the engine builder used rtv in the seal...
I got the dipstick and tube from bulltear.
I have a fresh, zero mile, reman 360 that I just put in my Jeep. I ran it for 20 minutes for cam break in with no oil leaks. Before shutting it...
So after checking some bearings I've decided to do a rebuild. Tim, I have purchased the book that you suggested. I have the engine torn down and...
The heads weren’t/aren’t removed. I don’t have a problem with installation or removal of the engine from the Jeep. I don’t however have any...
Now I don't know what I'm going to do again. I guess I've got some thinking to do. I'm don't know what all is wrong with the 304. It has low...
Thank you. It is tempting to throw it together and run it. Feels like my Jeep has been down forever. I think that I would be more comfortable...
It's replacing my original 304 which has taken a complete dump. I thought I might get away with purchasing a runner and upgrading to a 360 for a...
I guess my post was a little confusing. The engine that I have and am using and am inquiring about is an AMC 360. The guy I bought from is going...
I purchased a 360 that had been pulled to re-gasket but then they decided to replace it with a chevy. He said it ran well and didn't have any...
Separate names with a comma.