1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by Lilbuff63

  1. Lilbuff63
    Post

    My 1958 Cj5 "work In Progress" - Updated 12/10/2024 Roll Bar Fab On Pg.3

    Looking good, congratulations!
    Post by: Lilbuff63, Dec 10, 2024 at 9:18 PM in forum: Builds and Fabricators Forum
  2. Lilbuff63
    Post

    Ugh, Battery Drop To 10.3 When Cranking.

    Do you have your frame and body grounded as well? Check your voltage at the ignition and also make sure nothing is touching there, also make sure...
    Post by: Lilbuff63, Nov 11, 2024 in forum: Early CJ5 and CJ6 Tech
  3. Lilbuff63
    Post

    T.m.'s 4-speed Swap Thread.

    Just wanted to put my opinion here on the AA chain clutch linkage. I have had it installed on my Jeep with the SM 420 since I built it and with 4...
    Post by: Lilbuff63, Nov 6, 2024 in forum: Builds and Fabricators Forum
  4. Lilbuff63
    Post

    My 1958 Cj5 "work In Progress" - Updated 12/10/2024 Roll Bar Fab On Pg.3

    Nice work and congratulations on the progress! It’s an exciting time getting the finishing touches put together. The little details seem to be the...
    Post by: Lilbuff63, Oct 12, 2024 in forum: Builds and Fabricators Forum
  5. Lilbuff63
    Post

    Ford Box Mount

    I had the same experience as @Buildflycrash and after mine failed on the Rubicon I switched to Saginaw with hydro assist. With the 4.3 v6 and Ford...
    Post by: Lilbuff63, Sep 11, 2024 in forum: Early CJ5 and CJ6 Tech
  6. Lilbuff63
    Post

    Ford Box Mount

    https://www.ebay.com/str/ezsteer
    Post by: Lilbuff63, Sep 10, 2024 in forum: Early CJ5 and CJ6 Tech
  7. Lilbuff63
    Post

    Body Alignment

    [ATTACH] With six 1/2” studs going through the crossmember to a plate welded to the bumper, and I added an angle bracket that bolts to the frame...
    Post by: Lilbuff63, Jul 22, 2024 in forum: Early CJ5 and CJ6 Tech
  8. Lilbuff63
    Post

    Body Alignment

    Hard to get a good picture with the bumper mounted but the body should be pretty much flush with the rear crossmember. [ATTACH]
    Post by: Lilbuff63, Jul 21, 2024 in forum: Early CJ5 and CJ6 Tech
New Posts