1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by brad_cj5

  1. brad_cj5
    Post

    New Clutch won't disengage - Very Frustrating

    I dropped the trans tonight and it was indeed that the clutch disk was backwards. I appreciate the help in correctly diagnosing this prob. I...
    Post by: brad_cj5, Apr 20, 2009 in forum: Intermediate CJ-5/6/7/8
  2. brad_cj5
    Post

    New Clutch won't disengage - Very Frustrating

    Thank you for all the help, Your forum support is awesome. I'll give an update of what I find Thanks again Brad
    Post by: brad_cj5, Apr 17, 2009 in forum: Intermediate CJ-5/6/7/8
  3. brad_cj5
    Post

    New Clutch won't disengage - Very Frustrating

    I'll double check the transmission, that could complicate things
    Post by: brad_cj5, Apr 16, 2009 in forum: Intermediate CJ-5/6/7/8
  4. brad_cj5
    Post

    New Clutch won't disengage - Very Frustrating

    I am going to conclude that the disk is backwards since I adjusted the linkage out a lot more than it was with no results. I'll drop the trans...
    Post by: brad_cj5, Apr 16, 2009 in forum: Intermediate CJ-5/6/7/8
  5. brad_cj5
    Post

    New Clutch won't disengage - Very Frustrating

    The clutch plate is flush against the flywheel so I believe it is installed correctly
    Post by: brad_cj5, Apr 15, 2009 in forum: Intermediate CJ-5/6/7/8
  6. brad_cj5
    Thread

    New Clutch won't disengage - Very Frustrating

    Thanks for checking out my problem. I have a 74 CJ5, 304 T150 that had a new Luk clutch kit installed in it by a mechanic. After the install I...
    Thread by: brad_cj5, Apr 15, 2009, 13 replies, in forum: Intermediate CJ-5/6/7/8
  7. brad_cj5
    Post

    75 cj5 steering question

    Ok, its been a few months and I finally focused again on my steering issue. (I had to swap engines, and I also bought a semi-built xj that I...
    Post by: brad_cj5, Jan 5, 2009 in forum: Intermediate CJ-5/6/7/8
  8. brad_cj5
    Post

    74 304 Engine Install Problem

    Thanks for the advice, I got her bolted in. I was first going to unbolt the transmission mount on the crossmember, but opted to just unbolt...
    Post by: brad_cj5, Jan 5, 2009 in forum: Intermediate CJ-5/6/7/8
  9. brad_cj5
    Thread

    74 304 Engine Install Problem

    Hi, I am trying to put my 74 back together. It has a 304 with 3 speed. The engine is bolted to the trans and I have the driver's side motor...
    Thread by: brad_cj5, Jan 3, 2009, 5 replies, in forum: Intermediate CJ-5/6/7/8
  10. brad_cj5
    Post

    304 not running right, please help

    ok. I started it up, took off the top of the carb, and adjusted the float (it was close). How touchy is the float level relative to proper carb...
    Post by: brad_cj5, Aug 3, 2008 in forum: Intermediate CJ-5/6/7/8
  11. brad_cj5
    Post

    304 not running right, please help

    Thanks for the replies. I will check the vacuum issues and point gaps, as well as timing. Would an engine idle and rev up well if the timing were...
    Post by: brad_cj5, Aug 3, 2008 in forum: Intermediate CJ-5/6/7/8
  12. brad_cj5
    Thread

    304 not running right, please help

    Hi, I have spent hours on here searching through posts and hours in the garage trying to get my 74 CJ5, 304 going. Rebuilding the carb is the...
    Thread by: brad_cj5, Aug 3, 2008, 11 replies, in forum: Intermediate CJ-5/6/7/8
New Posts