The old girl runs, not driving yet. Carb leaks, so that's on the workbench for a rebuild. Need to adjust clutch, BL screwed it up. I will replace...
[IMG] Last fall, off to be welded. Nice fit on that trailer. Love these small jeeps. [IMG] Major work was rear corner and cross member. All...
Yup thanks. it helped after I got some of the gunk off.
Ok. 804A16 1975 April 16 258 Unless the first number is a 6? Hard to read those suckers. It would almost have to be a 6. Otherwise the block...
On a related note..is it possible to remove lower half of flywheel cover? Seems like on my CJ7 I could do that...I want to be able to get a better...
Just to double check things for me- my VIN is J3F835TA That gives me a '73 with a 3 spd and a 258, right? Engine cast number is 3218616 that is a...
Huh. Thanks. I decided to order new floor support for both sides.
Huh...that's a big pic. I kinda of need to know how it's aligned with the piece to the right (looking at pic). I realize the whole floor support...
I'm trying to fab up new floor support/body mounts and I'm not sure where the front mount was located. I think it is inboard of the piece that...
The secret revealed. When installing the hub inner body (?) or this part... [IMG]....it needs to be whacked with a hammer -dead blow and/or block...
The little bugger to the right has cracked. I'm going to try to back it off, re-seat the bearings (I have he correct large socket) and re-install....
Yup, I accounted for that. It looks like that little lock ring has cracked (as was warned in other threads). I'm beginning to not like this Jeep....
Separate names with a comma.