Yes the way it is installed it is increasing positive camber
I have the Motorola alternator and regulator that came off my 72, it was working when I took it off about 6 years ago, but it is only rated at...
The shift forks in my T14 from my 72 had the plastic coating
Pinion bearings and carrier bearings don't usually cause binding, they normally just make noise, if you don't have any experience working on...
If it sat for a while with moisture in the front differential then it might have rust buildup on the ring gear or pinion.
What kind of hubs does it have, if they say Warn Lockomatic on them then you won't be able to turn the front driveshaft if the wheels are on the...
Re: Gasket replacement on T14 transmission and Dana 20 TCase. Tools needed? instructi T14s like to leak at the front of the case where the end of...
Since you are in Texas, there is a Jeep salvage yard in Pasadena called Pasadena 4X4 it is on Beverly off of Spencer Hwy, he has a lot of jeep...
Yes the water jacket is right behind the water pump.
Darn it! came in second place
Take the outboard brake pad off and bend the 2 tabs that are away from the hub down a little in the direction of the hub then install them back in...
Tim is right my 72 has a bag mounted to the left fender well, I took my pump apart a few years ago and got it working but the plastic housing was...
You can also go the Chevrolet 250 6 cyl HEI route, all you have to do is take the distributor gear and spacer off of your points distributor and...
Yep that's what it looks like, thanks for the pictures.
Manual steering box shafts are smaller than power steering box shafts so the pitman arms are not interchangeable, however a manual pitman arm for...
Separate names with a comma.