I am looking for a filler neck, the metal piece that is held on to the body with two screws. This is the piece that the filler hose connects too...
Here is a link from Warlock when I was having issues with my 231: http://www.novak-adapt.com/knowledge/clutches_etc.htm Also in my post New Clutch...
Well, pulled the clutch boot and it was alittle hard to see, but I found the problem. My clutch fork jumped off of the T/O bearing and was in...
Thank you all for the advice, I just got back from camping. I am hoping to get back after it in the next couple of days. Thank You again,
I don't know, atleast I thought I did. Thank You, atleast I have a starting point...will investigate.
I have searched the forum, but could find similar issues with a new clutch so here are my issue. I finally found the time to finish putting my...
I have been searching and searching for a thermostat bypass hose for a 231 buick, would think a hose off a 225 would work as well. Went down to...
Thank You, I'll look at that part number, also thought a 7447 might work.
That is what I have been attempting to do, but the hose seems to pinch. So that is why I want to find a molded one.
I am looking for either a NAPA part number, any other part number, or source for a Water Pump By Pass Hose for either a 225 or 231. I have found...
My 71's brake block & front pressure switch is basically in the same locaction as yours. Just as dnb5853 stated, a tube bender & I would add a...
Separate names with a comma.