Hmm, I like both. I really liked the CJ-8 one of the magazines did where the bobbed off a big section of that rear overhang. You can always build...
I've done a few SOAs in the past. The current 69 (which I still haven't went to fetch) has an SOA but I'm sure it will have to be reengineered....
Looks great. I've been using 20 MM cans for years for all kinds of stuff. As long as it's dry inside when you put the lid on, it will stay dry. In...
Can you still put on the original lid? Maybe add some locking mechanism to prevent skullduggery?
FWIW I tie mine into the frame. I also make the mount so that it uses a shackle type mount under the bar and spring bushings between that the the...
I use GM Heatvalve Lubricant. It's a step up from Kroil which is pretty good stuff. The dealership where I get the stuff calls it the spray from God!
Thanks Mickmil, I knew someone would pipe up.
Look here; http://www.jeeptech.com/convxfer/scout300.html and here http://www.froadin.com/tcase.html
The scout case me just be the ticket. It shares the same bolt pattern as the Dana 18 in your Jeep now. Not sure on the internal stuff though. I'm...
Scout 300 cases are fairly sought after here for sure. Are you looking to replace a 300 in a Jeep or swap up to one?
IIRC, the scout 300 has the texas bolt pattern like the D18 and D20
5 on 5 1/2 for sure
Well, it could have been much worse. Whence you get inside the engine, report the findings. Any decision on what will be going back in?
How bad did you get hurt on these?
So what years/engines had the big hole case? Thinking my 69 :v6: might have it.
Separate names with a comma.
