Well found the problem. Finally started thinking a little and went to the library and found a manual for a 73 jeep and found I had the brake power...
Resistance is good because the right hand side does work and flash and it is the same setup as the left. As for shorts, I can make all the...
Both rear lights are LEDs and the fronts are incandesents which is enough resistants to drive the flasher. I am tempted to buy a new turn/hazard...
I am finishing up wiring my 58 cj with a ez wiring harness and I have just one issue that I am not sure about. For some reason my left rear turn...
This does help. Not sure if I am going to put the fuse box inside a waterproof container or not. It is an idea I have bouncing around in my...
John, Very nice diagram! Way better computer talent than I have. :) If I am thinking correctly your diagram is wired using a duel element 1157...
Ok now I understand by running the ground circuit of the running lights thru the turn signal switch to where the turn signal switch is in a...
I thought the turn signal and running lights would be open when not in use. One side of the bulb is grounded to the frame and the other would be...
Never thought about running the 1157 with dual elements but that is what I will do. For some reason I had it stuck in my head that I needed to...
Picked up the ezwiring harness for my jeep last week and I am trying to decided on which route I should use to run the wires to the back of the...
I bought a top from Best Top and it does fit on my CJ6. I had to make sure the windshield to back measurement was correct. Mine was off a...
sorry double posted
Count me in for a CJ6. Mine is a 58 bought from the origional owner. My dad drove it when it was new and 40 years later we have it. Came from...
Separate names with a comma.