I just put a 70-76 tank in my M38. If I were to do it again (got good deal on tank), I would put in a 76 to early 80's tank. The filler is on the...
I used pipe end caps (4), drilled hole for bolt and used them as a spacer (1"). Got info from this forum.
My experience with Herm's conversion has been very frustrating. Have a 67 Chevv 283 in my M38 and am doing Herm's conversion on mine (believe that...
I put a chevy 283 in my m38 in the late 70's and am doing a frame up on it now. Had the same problem with the front drive shaft rubbing on the...
Sounds like I should remove the can and plug the hole as I do not have that type of air filter. Much smaller because of clearance between...
I have a Chevy 283 in my 52 M38. The engine has been rebuilt and am connecting up hoses. There is a can at the back of the engine block for...
I am doing a frame up on an M38 and have several parts that I no longer need as a result of the conversion work I am doing. As an example, I have...
Thanks for the replies and comments. Went back to just one seal as I did not like how hard it was to turn the yoke with the two seals. Tried...
Rebuilt D18 and still had leak at rear yoke. Did a search and read many of the suggestions of using a double seal and using RTV on the spline. Did...
I have the original rims. Been painted over so they would need a good cleaning but you can still see the army color on the back.
Been looking for some 16" 5x5.5 for my 52 and they are hard to find.
Thanks much!! That's just what I needed to know.
Separate names with a comma.