agree with J Michael do the cut like this I I / / I I use the angle of the inner guard make sure the dims of the infil are 20" and...
Hi Guys just replaced ball joints on my open knuckle dana 30 I have to replace the oil seal the presses into the back of the spindle and runs...
My DIY jeep trailer it's based on the trailers used by the Aussie army for use behind landrovers mine of course uses early cj springs and is 5...
I stretched my 56 CJ5 sssh don't tell anyone when I cut the chassis I cut it at 45 degrees, so the welds in the top and bottom flanges aren't in...
that's good stuff Bob I like the look of the McQuay-Norris Extreme series Ball Joint could be the goods
bit of a toss up between the Moog's and the Spicers have to buy online, because I'm in Oz are the Spicers greaseable? found this spicer part no...
the bell housing you need is the one that goes between a 258 and a t5 manual tranny I did this swap in my old cj8, you had to drill and tap one...
The Lower ball joints on my CJ are flogged out again after about 12 months of hard work, jeep doesn't see a lot of road miles, an it's pretty...
Big advantage of a full floater is, if you break an axle you can pull the broken bits out, and drive home on the front, I've done it twice now
why go for a t18, I have and np435, and love it, easy to rebuild and was a matter of drilling and tapping 2 holes in the jeep bellhousing to get...
ARB are making some monster diff covers that would help brace up the 44
carter 7psi fuel pump works for me without a pressure regulator just dumped my projection too, after the ECU shat
Aussie ebay economaster http://cars.search.ebay.com.au/economaster_Cars-Bikes-Boats_W0QQfkrZ1QQfromZR8QQsacatZ9800
Separate names with a comma.
