1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

jeep2003's Recent Activity

  1. jeep2003 liked 73 cj5's post in the thread What's your other project (non Jeep) . . . show them off here!.

    My newest acquisition. 94 K1500... two reasons for the purchase are it has a unique drivetrain and it's a single cab 4x4. This unit is...

    Dec 8, 2022 at 8:46 AM
  2. jeep2003 replied to the thread Fc-150 Resurrection.

    Now im diggin into the passenger door. Got the skin off so i can tidy up the inside and fix along the bottom and such. Also painting the...

    Dec 7, 2022 at 5:33 PM
  3. jeep2003 replied to the thread Cold-weather Jeeping Tips: Part 1.

    Well I wondered about that original valve because i put one on my cj5 and im not sure if its completely blocked off because it still...

    Dec 5, 2022 at 5:04 PM
  4. jeep2003 replied to the thread Cold-weather Jeeping Tips: Part 1.

    My 911 is like that too. and i only have one side hooked up. Normally there is a seperate blower in the engine compartment that blows it...

    Dec 5, 2022 at 8:32 AM
  5. jeep2003 replied to the thread Cold-weather Jeeping Tips: Part 1.

    I'll have to check for the bypass. Yes iv done the piece of pipe bypass on my v6 and it works fine and really not difficult or messy. I...

    Dec 4, 2022 at 10:55 PM
  6. jeep2003 replied to the thread Cold-weather Jeeping Tips: Part 1.

    For the summer on the f head is it ok to put in a valve to completely shut off the water flow to the heater?

    Dec 4, 2022 at 8:57 PM
  7. jeep2003 attached a file to the thread Fc-150 Resurrection.

    I got my tires mostly mounted and installed they look good. Not exactly the look i was envisioning but its a good look . I got the door...

    IMG_2393.JPG Dec 4, 2022 at 5:54 PM
  8. jeep2003 replied to the thread Front Disc Conversion Turned Into Front Axle Work.

    Iv had more bad lower bearings than top ones. Because all the junk collects at the bottom.

    Dec 3, 2022 at 5:54 PM
New Posts