Just bought some garage floor mat material at Autozone.....going to try an cut to fit....hope I can make it look good. Not sure how well it will...
Exactly...thanks. Didn't think about Harbor Freight. Will check Oreilly's too.
Wanting to custom cut a vinyl mat fornthe front floorboard for my'65 Tuxedo. The standard Jeep suppliers have various versions with different...
Thanks guys...good info. Yes, I was thinking about the pinion bearing as well....I can't detect any side to side movement, but I have not pulled...
65 CJ5 wihich now has a D44 rear and a D20 transfer case. Have had new clutch and pressure plate installed. Transmission torn down and inspected....
High teens for quick sell...low 20s if you have some time. Just my gut feeling.
None of the big 3 auto part stores here list a UC12 part number for a 12v coil. What vehicle can I specify that would have had an appropriate coil...
Thanks, but already have a new ballast resistor. Just wanted to make sure I bought the correct coil. The coils listed at autozone for the '65 CJ5...
May have fried my coil on '65 CJ5. Has been converted to 12v. Cannot find a ballast resistor between the ignition and coil. Should I buy a 12v...
Exactly!!!
Thanks Nick...don't really have a vibration issue as much as a "rattly" sound when in 3rd. There is no noise when transfer case disengaged and...
Yes...Dana 20 and centered rear differential. I'm guessing I prolly ought to go ahead and just buy a new front driveshaft if I can find the right...
Separate names with a comma.