Haven't found any for a jeepster, but I did find some for a scout that might work and then I found this on ebay 304 Stainless Steel Filler Neck...
That is exactly what I needed to see and exactly what I thought was happening! Thanks Jpflat2a! What does it list for a part description for...
Got a 1970 Jeepster Commando work project. Its a Commando body on a JK chassis with a chevy LQ4, auto trans, atlas drivetrain. Needless to say...
I would definitely mount it low between the framerails if you can. You can check my build thread here for mine, "just a small project", it should...
When I did my chevy front 44 I cut it down to 58" wide width. I had currie cut and respline my shafts, I believe they were charging $70 a shaft...
The HO head flows better=more power. If you decide to go fuel injection, the HO injection system is better. The non-HO will work, but if you...
I'm no expert, but they all appear to be the same thing to me. The last two are actually made by the same company CCH or Clearwater Cylinder...
My bad! Didn't know that was banned. Oh well! Kevo
No, a stroker uses the 258 crank and rods in a 4.0 block. The 258 has a longer stroke and the 4.0 has a bigger piston bore. It sounds like...
Separate names with a comma.